But if you have a conditioned attic the insulation will be installed between attic rafters and perhaps directly beneath the rafters as well to keep the attic comfortable when it s uncomfortably hot or cold outside.
Insulating gable ends in conditioned attic.
You can use rigid foam panels or do as tom silva does with nearly all houses these days.
Attaching wooden strips vertically on the gable wall and then installing the foil inside each bay created by the wood strips is the easiest way to do this.
In most cases the existing insulation on an attic floor should be removed when an unconditioned attic is converted to a conditioned attic.
Usually the only time you would insulate a gable end is when the other side of it is a heated living space in your home.
The loss of energy efficiency means some designers choose to move the ductwork into the conditioned areas of the home and leave the attics unvented.
The superattic system utilizes proprietary silverglo rigid foam insulation panels to fully seal and insulate the attic directly beneath the roof rafters and directly inside the gable ends.
However this recommendation should be addressed on a case by case basis.
Once you get the gable ends framed correctly you will be able to insulate the attic.
On the gable ends a flash inch of closed cell for air sealing and compressed 3 thick rock wool sound abatement batts or compressed r13 fiberglass unfaced or kraft faced just not foil faced would work from a moisture point of view.
When insulating a attic there is usually no need to insulate the gable ends so long as the attic floor has been insulated.
Hire a pro to install spray foam insulation.
That would be about r17 at center cavity but no thermal break over the framing.
If you re considering turning your attic into conditioned storage or living space it s worth changing tactics to insulate between the rafters and wall joists instead of the floor.
Poorly insulated ducting can cause heat loss in colder months and the loss of conditioned air in the summer in vented attics.
When the attic becomes part of the home to be heated and cooled open wall gable vents and roof vents are no longer feasible but the underside of the roof the sheathing and rafters can still.
Staple the foil to the sides of the wood strips and make sure it won t sag or make contact with the deck when you add insulation.
An exception to the rule would be if you are installing a foil radiant barrier system.